Setting Up Your Nasuni Edge Appliance - Nasuni Edge Initial Configuration Manual

Configuring the Nasuni Edge Appliance

Setting Up Your Nasuni Edge Appliance

After configuring the network settings for the Nasuni Edge Appliance, you must enter your Nasuni.com
serial number and authorization code, accept the end-user license agreement, and create a user name
and password for the user who is a Filer Administrator of the Nasuni Edge Appliance.
Important: Internet connectivity (HTTPS port 443) is a prerequisite for setting up the Nasuni
Edge Appliance, or to update software during the installation.
To set up your Nasuni Edge Appliance:
1. After you have configured your network, open the specific URL to continue. The "Enter your
serial number and authorization code" wizard page appears.
Figure 1-17: "Enter your serial number and authorization code" wizard page.
2. Enter a Filer Serial Number and Authorization code, found under the Account section of
www.nasuni.com, or on the Account Status page of the Nasuni Management Console. For a
new installation, choose an unused Filer Serial Number. To recover a prior installation, such as
during disaster recovery, choose the Filer Serial Number of the prior installation. Click Continue
to proceed.
Note: If the administrative account for this Nasuni Edge Appliance was reset (such as, for a
forgotten password), and this Nasuni Edge Appliance was under the control of the
Nasuni Management Console, and if you are using the Filer Serial Number for that prior
installation, you must wait 1 hour from the time that you reset the administrative
account for the Nasuni Edge Appliance before entering the Filer Serial Number and
Authorization code and clicking Continue.
Nasuni Edge Appliance Initial Configuration Guide 8.3

Setting Up Your Nasuni Edge Appliance

37