Nasuni Edge Initial Configuration Manual page 105

10. Alternatively, to use static settings for the network device and the system, enter the following
command:
setall static
Press Enter. The setall static command runs:
Change values as necessary and save your values.
11. To exit the editnetwork commands, enter close.
12. To exit the console commands, enter quit.
13. On the Nasuni Edge Appliance, enter any changed settings so that the Nasuni Edge Appliance
is consistent with the platform.
Nasuni Edge Appliance Initial Configuration Guide 8.3
Figure B-8: setall static command.
Procedure
105