Workzone Q1W-SP02-2300B User Manual page 20

Troubleshooting
Fault
No pressure or only slight
pressure is built up.
Large fluctuations in
pressure
The washer has a leak.
26
Cause
There is air in the washer.
There is no water or an
insufficient supply of water.
The dirt filter is clogged.
The washer draws in air.
The high-pressure nozzle is
clogged.
There is insufficient water
pressure.
The water inlet hose is
kinked.
The connections of the
water inlet hose are loose.
The pump or the internal
connections
have a leak.
Solution
Operate the washer
without connecting the
11
spray gun until the
water is dispensed
without bubbles.
Check your water
connection.
Check the water inlet hose
for leaks or blockage.
Clean the dirt filter; see
section "Cleaning the dirt
filter".
Check for leaks in the water
inlet hose.
Clean the high-pressure
nozzle; see section
"Cleaning the high-
pressure nozzle".
Check the water pressure.
Check the water inlet hose.
Tighten the adapter on the
screw connection for the
water inlet adapter
and the screw connection
on your water tap until
hand-tight.
Contact the manufacturer
or an authorised service
centre at the service
address specified on the
warranty card.
17