Connecting Loads; Connecting Solar Module - EFOY ProEnergyBox 4060P User Manual

3. Operation
3.7

Connecting loads

•
A
•
B
Connect loads that must not be deactivated by the solar charge controller deep
discharge protection, e.g. emergency lights or radio connection, directly to the
battery.
Loads with a higher current consumption than the device output can be directly
connected to the battery. However, the solar charge controller deep discharge
protection will no longer intervene. Loads connected in this manner must also
be separately fused.
3.8

Connecting solar module

•
A
•
B
Please refer to chapter 2.3 Specifications on page 11 regarding
maximum discharge currents.
Contact pin assignment for load plug-in female (view onto
connector):
A: Battery voltage + (12 / 24 VDC)
B: Ground - (GND)
Please refer to the enclosed manual ASSEMBLY AND WIRING
INSTRUCTION for MS / CA-BAYONET from ITT CANNON for
wiring operations.
Please refer to chapter 2.3 Specifications on page 11 regarding
maximum solar charge currents.
Contact pin assignment for solar plug-in male (view onto
connector):
A: Battery voltage + (12 / 24 VDC)
B: Ground - (GND)
Please refer to the enclosed manual ASSEMBLY AND WIRING
INSTRUCTION for MS / CA-BAYONET from ITT CANNON for
wiring operations.
15