Mp30 Cable Connection - QED MP30 Instruction Manual

6. If the drawdown level exceeds the selected drawdown limit point too
consistently, the flow purge flow rate can be further decreased with
adjustment of the controller, typically through one or more presses of
the flow "down arrow" key. If the flow rate is already at or near a
minimum desired rate, in some cases it may be also possible to lower
the probe to a new, lower drawdown control point to increase the well
recovery rate. Consult regulatory considerations before adjusting
protocols.
Figure 1
Sensitivity Control
Unit On/Off Switch
Panel Knobs

MP30 Cable connection

1. Cable connects to identical ports on MP30 and basics controllers, labeled "Control Port".
2. Connect cable to MP30 after reel has been turned to lower probe to desired drawdown
control point, to avoid twisting cable while tape reel turns.
Drawdown Control Quick Guide
Contol Port
Speaker
Speaker On/Off Switch
Drawdown Control
On/Off Switch
Probe Submerged
Indicator
OPERATION
Level
Shut Off
Indicator
2