Related Manuals for Metos BCF40
Summary of Contents for Metos BCF40
- Page 1 BLAST CHILLER / SHOCK FREEZER ICER BCF20, BCF40 Installation and User Manual 30.12.2015 MG4249072, MG4249074...
-
Page 2: Table Of Contents
30.12.2015 METOS ICER TABLE OF CONTENTS Introduction ...............................3 Technical data ............................3 Manufacturers responsibility and rights ....................4 Transport and storage ..........................4 Commissioning ............................5 5.1. Installation ..............................5 5.2. Cleaning prior to commissioning .........................5 5.3. Eelctrical connection ...........................6 5.4. Drain ................................6 Technical data ............................6 6.1. -
Page 3: Introduction
30.12.2015 METOS ICER Introduction These devices are designed considering the user’s needs and preferences. The devices are checked at the factory before dispatch. Carefully read the instructions in this manual as they contain important information regarding proper, ef- ficient and safe installation, use and maintenance of the appliance. -
Page 4: Manufacturers Responsibility And Rights
30.12.2015 METOS ICER Manufacturers responsibility and rights It is forbidden to make changes to the appliance without authorization of the manufacturer. The manufacturer is not liable for damage caused by: • regulations to instructions in this manual have not been followed •... -
Page 5: Commissioning
30.12.2015 METOS ICER Commissioning Note the rating plate and warning decals. These should under no circumstances be covered and they should be immediately replaced if damaged Do not remove protection or panels that requires tools. 5.1. Installation Place the unit on a flat surface. Leave sufficient space round the appliance for use and service. -
Page 6: Eelctrical Connection
30.12.2015 METOS ICER 5.3. Eelctrical connection Before making the connection to the mains, ensure that the voltage and frequency are as indicated on the appliance rating plate. Never use sockets or plugs without earth connection. Never use extension cords. Ensure that the unit’s power cord is not stretched or pinched. The cable must not come into contact with sources of heat or liquid. -
Page 7: Operation
7.1.1. Electrical connection BCF20: connect the plug to the wall outlet BCF40: connection may only be carried out by qualified professional staff. When the unit is connected to the mains the display lights up showing current internal temperature. 7.1.2. Start Select the desired program while the unit is in “STOP”... -
Page 8: Selecting And Starting A Function
30.12.2015 METOS ICER 7.3. Selecting and starting a function General - Do not open the door once the cycle has commenced and until the cycle has terminated. - Avoid wrapping, protecting or closing containers with lids or insulating films. - Do not use trays or containers deeper than 65mm. 40 mm deep trays are recommended. -
Page 9: Defrosting
30.12.2015 METOS ICER 7.4. Defrosting During the conservation cycle the defrost function is automatic. If several blast chilling / shock freezing programs are run sequentially, it is advisable to sequentially start manual defrost. Defrosting starts by pressing the manual defrost button while the device is in the ON position. -
Page 10: Troubleshooting
30.12.2015 METOS ICER Troubleshooting Often, the malfunction of a unit is due to simple causes which can easily be fixed If the cabinet does not operate, make sure that: • The plug has been correctly inserted into the socket. • The supply cord is not damaged. -
Page 11: Spareparts
30.12.2015 METOS ICER 10. Spareparts Switch off the appliance in case of failure or malfunction. Have the appliance serviced by a technically qualified person authorized by the manufacturer and using original spare parts. If the unit’s power supply cord or socket is damaged it should be replaced immediately by qualifi ed professional 11. - Page 12 30.12.2015 METOS ICER...
- Page 13 30.12.2015 METOS ICER...
- Page 14 30.12.2015 METOS ICER 1300g 980W BCF20 BCF40...
Need help?
Do you have a question about the BCF40 and is the answer not in the manual?
Questions and answers