Key Fob Pairing - Haven Lock CONNECT Quick Start Manual

7 HAVEN CONNECT

KEY FOB PAIRING

H
I
J
Both lights should blink together and you will hear a beep to signify that the pairing was
3
successful.
If you do not hear the beep and your key fob does not function or flashes red, you will need to
4
hold the HAVEN Admin Button ( B ) for about 10 seconds to reset (LED will flash green) and then
start the process over again. (Note: resetting the HAVEN through manual reset also disconnects any
synced phone applications that will need to be re-keyed via the mobile application).
KEY FOB RESET
When a HAVEN Key Fob needs to be cleared of its paired connection to HAVEN Connect, it must go
through a reset process.
Hold Lock Button for 4 Seconds - On the enrolled key fob, hold down the lock button ( J ) for
1
approximately 5 seconds.
2
Wait for Flashes - A short series of flashes will appear, momentarily stop and then reappear.
Fob Restarts - The fob will then automatically restart. Upon powering back up, an alternating
3
series of green, red, blue and white flashes indicate that the fob is powered on.
Ready for New Enrollment - The key fob has been successfully reset and the preexisting
4
enrollment has been cleared.
(purchased separately)
LED Status Indicator
Unlock Button
Lock Button
Touch the key fob against the HAVEN
1
Connect Status Indicator LED ( A ) and press
and hold the key fob lock button ( J ) for 5
seconds until the Key Fob LED Status
Indicator ( H ) illuminates and blinks white.
Continue holding button ( J ).
While still holding the key fob lock button,
2
press and release the HAVEN Admin Button
( B ) and when it starts blinking white, release
the lock button ( J ) on the key fob.
Need help? Contact us at support@havenlock.com