Install Backup Batteries - Haven Lock CONNECT Quick Start Manual

5 HAVEN CONNECT
PREPARING YOUR HAVEN CONNECT
Status Indicator LED
A
C
Control Panel Cover
D
Charging Port
B
Admin Button
Charging
1
Plug the included charging cable (USB end) into the included power adapter. Open the HAVEN Control Panel
cover (C) and plug the charging cable into the Charging Port (D). Allow HAVEN to fully charge 6-8
hours before use. This is a good time to set up your account at www.myhavenlock.com or on the mobile
app.

Install Backup Batteries

2
Using the 3 include E90 Batteries, place them according to the battery placement indicator in the backup
battery slot (G).
Cycling the Lock
3
Cycling the lock a minimum of 10 times prior to installation ensures that the nylon straps inside the lock
are properly stretched and calibrated. During shipment parts can settle and this cycling allows the parts to
"stretch" and maximize their effectiveness. A "cycle" is simply locking and unlocking the lock via the foot pedal
(F) and lock gate (E). Cycling the lock via the key fob or app a minimum of 5 times helps ensure the servo
motor is properly engaged and ready for use.
Remove Locking Gate Cover (E)
4
If you are ready to mount and install the HAVEN Connect, remove the HAVEN locking gate cover by
removing the 4 small screws (Phillips head screwdriver) on the back of the locking gate, as seen below:
Control Panel (with cover lifted)
_
+
R
1
+
E
Locking Gate
2 3
+ +
F
Manual Foot Locking Pedal
G
Backup Battery Slot
Factory Reset (using pin)
4
+
Need help? Contact us at support@havenlock.com