Mode Selection (Count Or Value) - Talaris 177-0600 User Manual

Model: EV8650
3.5

Mode Selection (Count or Value)

1. Display
2. Total
3. Mode
4. Batch
5. Start / Stop
6. Auto
Count or Value (dEntr)
Press the MODE key to display the current counting Mode.
Whilst the current counting mode is shown, press MODE again to toggle between the
available Modes.
Quick Access
Prior to using the Mode selection key, the supervisor can set up the Quick Access
Function. This allows the Supervisor to select the four most common mode selections
that they use. Two Quick Access functions in Count Mode and two in Value mode.
The second of each is typically set to oFF which means that the MODE key simply
switches between count and value operation.
Repeatedly pressing the MODE key will scroll though these four Quick Access modes.
Alternatively use the arrow keys to scroll through all of the other available modes.
Press START/STOP to return to the counting display or wait for the display to time out.
Modes that may be used include:
Count Mode
PIECE
FdEn
AdEn
Value Mode
d Entr
AdEn
TP05413002 Rev. 03
Copyright © 2009 by Talaris Ltd., Basingstoke (UK)
13
cnt For counting pieces of paper without attributing any value.
cnt (Fixed Denomination). For counting documents, all of a single
denomination but displaying the result as a count.
cnt (Automatic Denomination). For counting documents, all with the
same denomination as the first note fed but displaying the result as
a count. This is typically used in Size, IR or SMDS detection.
val (Denomination Enter) For counting pieces of paper and displaying
the result as a value based on a denomination entered by the user.
val (Automatic Denomination) For counting documents, all of the same
denomination as the first fed and displaying the result as a value.
Operating Instructions
1
12 11 10
7. Speed
8. Det
9. Clear
10. Right Arrow
11. Denomination
12. Left Arrow
13. Numeric Keypad
5
3
4
2
9 8 7
Page 17 of 62
6