Silvercrest KH 206 Operating Instructions Manual page 11

Installing the appliance
Select a suitable positioning for the transmitter, close to
your outer door.
Using the assembly plate h of the transmitter, mark the
positions required for the two boreholes (spacing approx.
68 mm) and then bore the holes for the enclosed wallplugs.
Screw the assembly plate h onto the wall.
Write the name(s) of the residents on the nameplate d
and then place the plastic covering.
Place the transmitter on the assembly plate h and
secure it, with the enclosed small screw, to the assembly
plate h.
You can install the receiver at a suitable location either
suspended by its loop o or make use of the stand u.
Bear in mind that the given range refers to the free-space
range. If being utilised in a building, this range is reduced
quite distinctly.
To suspend the receiver, fix the enclosed screw, with the
wallplug, at a suitable location on the wall and hang the
appliance from it.
- 9 -