6.12 Hinge Receivers; 6.12.1 Replacing The Hinge Receivers - Bosch 800 series Service Manual

58300000202443_ARA_EN_C
Figure 36 Cooling fan and outer housing
7. Remove the screw securing the fan to the plenum.
8. Disconnect the wires and remove the fan.
9. Install the new cooling fan and reattach the wires securely.
10. Restore power to the unit and test operation.
11. Reinstall housing cover(s).
12. Slide the unit back into the cutout and reinstall the side trim
pieces.

6.12 Hinge Receivers

To replace the hinge receivers, the oven must be pulled
completely out of the cutout to provide access to the side panel(s).

6.12.1 Replacing the Hinge Receivers

1. Remove power to the oven.
2. Remove the screws securing the right and left side trim pieces
to the cabinetry.
3. Carefully slide the oven out of the cutout to gain access to the
side housing panel(s).
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
JANUARY 2018
1 Cooling fan
outer housing
1
2 Cooling fan
2
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch 800 Series Built-in Wall Ovens
4. On double ovens, remove the corner brackets between the
upper and lower oven.
Figure 37 Double oven corner bracket
5. Remove the side panel(s).
6. From the front of the oven, remove the two screws securing
the hinge receiver to the oven.
7. Pull back the side insulation to reveal the hinge receiver and
remove the part.
Figure 38 Removing the RH hinge receiver
Page 29 of 43
800 944-2904