Singer 2263 Instruction Manual page 31

TROUBLESHOOTING AND MAINTENANCE
4
Troubleshooting
14. NEEDLE THREADER NOT WORKING
(for models with built-in automatic needle threader)
Possible Cause: Needle not in correct position
Solution: Raise needle to its highest position by turning hand wheel toward you. (See Page 15)
Possible Cause: Needle inserted incorrectly
Solution: Needle all the way up in needle clamp (See Page 25)
Possible Cause: Needle is bent
Solution: Remove bent needle, insert new needle. (See Page 25)
Possible Cause: Hook pin damaged
Solution: Needle Threader needs replacement; contact authorized SINGER
®
service center:
Visit www.singerco.com.
15. LOUD NOISE WHEN SEWING
Possible Cause: Thread not in take-up lever
Solution: Rethread the machine, making sure the take up lever is in its highest position so thread
goes in the eye of the take up lever – turn machine hand wheel toward you to raise the take up
lever to its highest position for threading. (See Page 14)
Possible Cause: Thread path obstructed
Solution: Check that thread is not caught on the thread spool or behind the spool cap.
(See
Page 14)
16. MACHINE WILL NOT RUN
Possible Cause: Bobbin winding spindle is engaged when you try to sew.
Solution: Disengage bobbin winding spindle. (See Page 12)
Possible Cause: Power cord and/or foot controller not plugged in correctly
Solution: Make sure power cord/foot control are correctly seated in machine and power supply.
(See Page 11)
Possible Cause: Wrong bobbins being used
Solution: Use only SINGER
®
branded bobbins that are same style as those that come with
machine. (See Page 10)
31