Singer 2263 Instruction Manual page 28

TROUBLESHOOTING AND MAINTENANCE
2 4
Troubleshooting
Possible Cause: Thread path obstructed
Solution: Check if thread is caught on thread spool (rough spots on the spool itself) or behind
spool pin or spool cap (if the thread has fallen behind the spool cap and therefore cannot feed
freely through the machine path). (See Page 14)
Possible Cause: Machine is not threaded correctly
Solution: Remove upper thread completely, raise presser foot lifter, rethread machine making
sure thread is in take-up lever (raise take up lever to its highest position by turning hand wheel
toward you. (See Page 14)
Possible Cause: Upper tension too tight
Solution: Reduce upper thread tension.
Possible Cause: Thread is old or poor quality
Solution: Rethread the top of the machine and bobbin with good quality thread. (See Page 14)
Possible Cause: The needle is either worn or old, or it is the wrong style or size for the thread
being used. Though it may seem that the machine is shredding the thread, it is usually the needle
causing this. If the needle is old or worn out, or if the needle is too small for the thickness of
thread, the eye of the needle can cause the thread to shred.
Solution: Change to a fresh needle in the correct size for the thickness/weight of thread being
used. (See Page 25)
Possible Cause: Top & bobbin threads have not been properly placed underneath presser foot
before starting to sew.
Solution: Ensure that both the top thread and the bobbin thread are under the presser foot and
toward the back before starting to sew. (See Page 20)
Possible Cause: Sewing was started with no fabric under the presser foot.
Solution: Place fabric under foot, making sure that needle comes down into fabric; lightly hold
Possible Cause: Needle inserted incorrectly
Solution:
it can go, then tighten needle clamp screw. (See Page 25)
Possible Cause: Wrong needle for fabric sewn
Solution: Use correct style & size of needle for fabric. (Go to www.singerco.com to view the
Stitch Reference Guide)
Possible Cause: Bent, dull or damaged needle
Solution: Discard needle and insert new needle. (See Page 25)
28
3. UPPER THREAD BREAKING
(See Page 18)
4. THREAD IS SHREDDING
5. THREAD BUNCHING AT BEGINNING
6. SKIPPING STITCHES