Operating Instructions; Section 4 - Operating Instructions; Controls And Instrument Identification - Scag Power Equipment V-RIDE SVR36A-20FX Operator's Manual

R
CAUTION
Do not attempt to operate this mower unless you
have read this manual. Learn the location and
purpose of all controls and instruments before
you operate this mower.
4.1 CONTROLS AND INSTRUMENT
IDENTIFICATION
Before operating the mower, familiarize yourself with all
mower and engine controls. Knowing the location, function
and operation of these controls is important for safe and
efficient operation of the mower.
1. Ignition Switch (Figure 4-1).
is used to start the engine and has three positions;
OFF, ON, and START.
ENGINE CHOKE
CONTROL
ENGINE
THROTTLE
CONTROL
HOURMETER

OPERATING INSTRUCTIONS

The ignition switch
IGNITION SWITCH
CUTTING HEIGHT
ADJUSTMENT
DECK LIFT
MOWER DECK
SWITCH
PARKING BRAKE
CONTROL
LEFT STEERING
CONTROL
Figure 4-1.
2. Mower Deck Switch (Figure 4-1).
and disengage the mower drive system. Pulling up
on the switch will engage the deck drive. Pushing
down on the switch will disengage the deck drive.
3. Engine Choke Control (Figure 4-1).
a cold engine.
4. Engine Throttle Control (Figure 4-1).
control the engine speed. Pushing the lever forward
increases engine speed. Pulling the lever back
decreases engine speed. Full back position is the
IDLE position. Full forward is the cutting position.
5. Hourmeter (Figure 4-1).
hours the engine has been operated. It operates
whenever the engine is running. Has preset
maintenance reminders for engine and hydraulic
system oil changes. Will start flashing scheduled
maintenance 2 hours before preset time and
continue flashing until 2 hours after. Automatically
resets.
Controls and Instruments
10
Section 4
Used to engage
Used to start
Used to
Indicates the number of
NEUTRAL LOCK
CONTROL
FUEL GAUGE
RIGHT STEERING
CONTROL