Scag Power Equipment V-RIDE SVR36A-20FX Operator's Manual page 24

Scag power equipment lawn mower user manual
Hide thumbs Also See for V-RIDE SVR36A-20FX:
Table of Contents

Advertisement

R
NEUTRAL ADJUSTMENT
-NOTE-
Neutral has been set by your Scag dealer at the
time of set up and normally does not need to be
adjusted. If, however, you find that the neutral
has come out of adjustment, follow the procedure
below.
1.
Be sure the dump valves are in the run position and
the speed control lever is in the neutral lock position.
2.
With an operator in the operating position, park the
machine on a flat level surface, start the engine and
disengage the parking brake.
3.
Run the engine at full operating speed and check if
the machine creeps forward or backwards.
4.
Adjust the RH wheel by loosening the jam nuts on
the steering control rod and turning the rod until the
drive wheel turns in the forward direction. Turn the
rod back until the drive wheel stops moving. Turn the
rod an additional 1/2 turn. See Figure 6-2.
Figure 6-2.
Tracking Adjustment Right Side
5.
Repeat for the LH wheel. See Figure 6-3.
LOOSEN
JAM NUT
ADJUST
HERE
LOOSEN
JAM NUT
6.
7.
LOOSEN
8.
JAM NUT
ADJUST
HERE
TRACkING ADJUSTMENT
Stop the engine and remove the key from the
ignition before making any adjustments. Wait
LOOSEN
JAM NUT
for all moving parts to come to a complete stop
before beginning work.
The engine and drive unit can get hot during
operation causing burn injuries. Allow the engine
and drive components to cool before making any
adjustments.
20
Figure 6-3.
Actuate the steering control levers forward and
reverse several times and return them to the neutral
position.
Check that the drive wheels remained in neutral and
readjust if necessary.
Check that the steering control levers hit the stop
before the pumps reach full stroke. Adjust as
needed.
CAUTION
CAUTION
Section 6

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

V-ride svr48v-24fxV-ride svr52v-26fx

Table of Contents