Before Installation; Ir Id Switch Settings; Service Switch Settings - Panasonic AW-UE150WP Operating Instructions Manual

Installation Instructions

Before installation

Be sure to configure the switches on the connector panel and bottom of the unit before installing it.
Configuring the switches after the unit is installed may prove difficult.

IR ID switch settings

The IR ID switches are located on the connector panel of the unit.
LAN
LINK ACT RS-422
12 V IN
IR ID
AUDIO IN
IR ID switch
CAM1 CAM2
These are used to select the ID of the wireless remote control (optional
accessory). (→ page 56)
The IR ID switch settings "CAM1" to "CAM4" correspond to the <CAM1>
to <CAM4> buttons on the wireless remote control.
8
SERVICE
3G SDI OUT G/L IN
OPTICAL
MONI OUT 12G SDI OUT
CAM3 CAM4

Service switch settings

The service switches are located on the connector panel of the unit.
Perform switch settings before turning the unit on.
Service switch
SW1 SW2 SW3 SW4
ON
OFF
LAN
LINK ACT RS-422
12 V IN
IR ID
AUDIO IN
Function
SW1 Switches for initialization
(Refer to the explanations in "Initialization 1"
and "Initialization 2")
SW2
Always leave at OFF (used for factory
SW3
adjustments)
SW4
Initialization 1
• Reset the user authentication settings and host authentication settings
for network connection.
(This will delete all the registered user information (IDs/passwords)
and host information (IP addresses).)
• With the IR ID switches and service switches set as shown below, turn
on the power of the unit.
OFF
<NOTE>
• When initialization is complete, the status display lamp on the front of
the unit blinks green. Restart the unit to confirm the initialization.
Initialization 2
• The unit is reset to the state it was in at the time of purchase. (All
camera menu setting values and network setting values are reset.)
• With the IR ID switches and service switches set as shown below, turn
on the power of the unit.
OFF
<NOTE>
• When initialization is complete, the status display lamp on the front of
the unit blinks green. Restart the unit to confirm the initialization.
SERVICE
3G SDI OUT G/L IN
OPTICAL
MONI OUT 12G SDI OUT
Factory settings
OFF
OFF
OFF
OFF
SW1 SW2 SW3 SW4
ON
SW1 SW2 SW3 SW4
ON