Stand-Alone Installation (When The Mount Bracket Is Going To Be Used) - Panasonic AW-UE150WP Operating Instructions Manual

Stand-alone installation (when the mount bracket is going to be used)

The same steps are followed as for the kind of installation where the unit is suspended from an overhead surface (→ pages 9 to 12).
1. Check the mounting space.
<NOTE>
• As with installing the unit suspended from an overhead surface, carefully check the space where the unit will be mounted, and then decide if it is
appropriate to install the unit in that space.
2.
Mount the mount bracket onto the installation surface.
3.
Attach the drop-prevention wire.
4.
Mount the unit.
• Align the position of the hole for checking the positioning with the status display lamp.
• Align the holes on the camera main unit used to insert the bottom panel with the protrusions on the mount bracket used for inserting the camera,
push the bracket and camera firmly together, and rotate the main unit by about 20 degrees in the direction of the arrow.
• Secure the mount bracket to the unit using the main unit mounting screw (M3) as supplied.
Status display
lamp
On the camera main unit:
Holes (×3) used to insert
the bottom panel
On the mount bracket:
Protrusions (×3) used for
inserting the camera
Hole for checking the
positioning
Attach the drop-prevention
wire.
Installation Instructions
Bracket mounting screws × 4 (supplied)
(M4, bind-head)
Approx. 20°
Main unit mounting screw
(M3 screw) (with flat
washer, spring washer)
15