Error Messages; Update Maps; Usb Hardware; Frequently Asked Questions - Polaris RideCommand User Manual

MAINTENANCE

ERROR MESSAGES

If an error occurs while updating your software, perform one or all of the
following actions to resolve the issue:
1. Remove and reconnect the USB flash drive securely.
2. Make sure the display files are not inside a folder on the flash drive.
3. Make sure only display files are on the flash drive. Remove any other files if
necessary.
4. Try using a different USB flash drive.

UPDATE MAPS

To update the maps on your display, do the following:
1. Go to ridecommand.polaris.com and download the map update to a USB
flash drive.
2. Insert USB flash drive into the USB port on your vehicle.
3. Press the Update maps in the General Settings.
4. Select the file you want to install by pressing the corresponding down arrow
icon.
5. This will update the display's map which will automatically restart the display
once the update is complete. Do not remove the USB flash drive until the
display has fully restarted.

USB HARDWARE

For software update, POLARIS recommends using a SanDisk® or similar USB
flash drive with a minimum of 4G in available memory, formatted using the
FAT32 file system. For best results remove all files from the flash drive before
starting the update process.

FREQUENTLY ASKED QUESTIONS

1. How do I update my map on my display?
Log in at my.polaris.com to download the latest MAPS/Software data. Then
transfer the files to the Display using a USB flash drive. Refer to Update
Software or MAPS/Software Data on page 9.
2. How do I find the USB connection on my specific vehicle?
Refer to USB Connection Locations on page 44.
3. Why does my display not acquire satellite signal or GPS?
The GPS can take a few minutes to lock from a cold start. After warm-up, if
less than 4 satellites are shown in the GPS satellite screen move the vehicle
to an area free of overhead obstructions. Refer to Satellite Status on page
29.
44