Table of Contents
Advertisement
Produktgruppe 19
44 von 46
Installation Instructions
Note
All repairs may only be performed by a trained technician in strict accordance with national, state and local codes.
Danger!
Protect from injury during installation.
Before starting any service or installation work, safely disconnect the appliance from its power source.
Install the stand only on washers/dryers that are not operational. For disassembly instructions, refer to the operating instructions
for the appliance.
Wear non-slip palm gloves and safety shoes to protect from injury.
Make sure that no body parts, especially hands and feet, get stuck under or between the machines.
Keep children and animals out of the work area during installation.
Protect from injury: For the installation, tip the washer onto its left side, and the dryer onto its right side.
Do not stand on the drawer!
Danger of appliance tipping over. Danger of injury due to faulty installation.
Always bolt the stand and the appliance together.
Each stand can be set up solo, or in combination with additional stands.
When combining several stands, always connect them with a snap connector.
In a solo setup, it is recommended to bolt the stand to the floor with the floor installation kit, mat. no. 04294300.
When floor mounting, secure at least two stand feet on the floor (at least one foot in front and one in the rear). A diagonal floor
mounting is ideal.
Fire hazard.
Do not store flammable materials in the drawers.
Warning!
Do not store wet or damp items in the drawer.
Note
Metric system.
The stand is only for Miele appliances:
W 2000, W 3000, W 5000, T 200, T 4000, T 8000 series.
Not to be used for integrable machines or washer-dryer stacks.
Note
Required tools:
Level for leveling the stand(s).
12 mm open-end wrench, to adjust the tilt of the stand front panel.
13 mm open-end wrench, for M 8 bolt.
17 mm open-end wrench, for M 10 bolt.
Phillips screwdriver, to adjust the height of the front panel.
Torx T 20 screwdriver, for back wall.
Pulling the drawer out of the stand
Pull the drawer out to its stop (Fig. 2).
Lift the drawer at the railings, release the drawer and take it out.
Installing the feet
Place the stand where it will ultimately be set up (Fig. 3).
Turn the feet until the stand is level.
If combining several stands: Make sure that all stands are set to the same height.
Check with a level.
Counterlock.
13.11.2012
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 07104212
Hide quick links:
Advertisement
Table of Contents
