Table of Contents
Advertisement
Produktgruppe 19
45 von 46
Installing the stand under a washer
Note
Drain all water from the washer.
With transport struts in place, put the washer onto its right side.
Place the washer on a level, soft surface, such as a carpet.
Put the washer onto its right side.
Unscrew the washer feet and take them off.
Thread two M 10 hex nuts each onto the M 10 bolts and counterlock so that 15 mm ± 1 mm (
Screw the M 10 bolts with the 15 mm (
Put a 10.2 x 32 x 2 washer on each bolt.
Bolt the stand and washer together.
From the inside of the stand, screw an M 10 hex nut with #10.5 washer onto each M 10 bolt, and tighten.
Screw the back wall onto the stand using the 4x10 fillister-head screws.
Set the washer/stand assembly upright.
Remove the transport struts.
The side panels of the stand have two holes each (Fig. 5).
When combining several stands, push plugs into the holes that are not used.
In a solo setup, push plugs into all four holes.
Installing the stand under a dryer
Note
Condenser dryer: Empty the water tank to prevent water leaking from the dryer during installation.
Place the dryer on a level, soft surface, such as a carpet.
Put the dryer onto its left side.
Unscrew the dryer feet and take them off.
Thread two M8 hex nuts onto each M8 bolt and counterlock, so that 12 mm ± 1 mm (
Screw the M8 bolts with the 12 mm (
Put a washer 8.5 x 30 x 3 on each bolt.
Bolt the stand and dryer together.
From the inside of the stand, screw an M8 hex nut with #8 washer on each M8 bolt, and tighten.
Screw the back wall onto the stand using the 4x10 fillister-head screws.
Set the dryer/stand assembly upright.
The side panels of the stand have two holes each (Fig. 5).
When combining several stands, push plugs into the holes that are not used.
In a solo setup, push plugs into all four holes.
Connecting the washer and dryer stands
If there are any plugs in the side walls to be connected, remove the plugs (Fig. 5).
Snap the snap connectors into the side wall of the washer stand (Fig. 7).
Push the dryer stand onto the free ends of the snap connectors until the connectors engage (Fig. 8).
Note
Washer, dryer and both stands must be aligned.
Connectors must engage with a visible and audible snap.
Inserting the drawers into the stands
Place the drawer onto the tracks and push it in.
To check that the drawer is seated correctly, open the drawer to its stop and close it again.
The drawer automatically clicks in as it is closed.
Adjusting the front panel
The front panel of the appliance and the front panel of the drawer must be aligned. After installation it may be necessary to align the
[drawer] front panel. The height and the tilt of the front panel of the drawer can be adjusted (Fig. 9).
13.11.2012
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
10
/
) side into the washer housing, to a stop, and tighten.
16
8
/
) side into the dryer, to a stop, and tighten.
16
Umbau- und Montageanweisung
M.-Nr. 07104212
10
1
/
±
/
) of thread is visible (Fig. 4).
16
16
8
1
/
±
/
) of thread is visible (Fig. 6).
16
16
Hide quick links:
Advertisement
Table of Contents
