Auto-Off; Invert Display - ANDILOG CENTOR FIRST Operating Manual

5. Auto-off

An Auto-off feature conserves battery power , the gauge powers down after 15 minutes since the
last key press.
To power down the gauge press the red key.
WARNING
If the CENTOR FIRST has suffered a serious overload condition, the load indicator bar will be partially
displayed even when no load is present. This is a warning that the load cell is damaged and you
should immediately contact your supplier to arrange repair.
Do not overload the load sensor. This will cause irreparable damage
. Forces greater than 100% of fullscale will produce an blinking display until load is released.
. Forces greater than 120% of fullscale will produce the word OVERLOAD display until load is
released.
The sensor will support 200% of fullscale without damage. In case of a permanant OVERLOAD is
displayed, consult your supplier to arange repair.

6. Invert Display

The display may be inverted or "reversed", so that the
operator can read it more comfortably. Press and hold
the ZERO and UNIT keys This feature is remembered
after power down
Pressing again ZERO and UNIT key will place the display in
original position.
- 8 -
Instructions Manual – V1
CENTOR FIRST