Makita DUR364L Instruction Manual page 13

4. Mount the spool in the housing so that the grooves
and protrusions on the spool match up with those in the
housing. Keep the side with letters on the spool visible
on the top. Now, unhook the ends of the cord from their
temporary position and feed the cords through the
eyelets to come out of the housing.
1. Spool 2. Housing 3. Eyelet
5. Align the protrusion on the underside of the cover
onto the housing to secure it.
For B&F ECO4R
Take off cover from housing, pressing two latches which
are slotted section oppositely on side of housing.
1
2 3
1. 80-100 mm
Cut a nylon line in 3 m. Fold the cutting line in two
halves, leave one of half longer 80-100 mm than
another.
Hook the middle of the new nylon cord to the notch
located at the center of the spool between the 2 chan-
nels provided for the nylon cord.
marked on the head for right hand direction indicated
by RH.
Wind all but about 100 mm of the cords, leaving the
ends temporarily hooked through a notch on the side of
the spool.
13 ENGLISH
1