Table of Contents
Advertisement
To access the ZEN online configuration tool, first connect the provided USB cable to the ZEN module, and to
the PC. Open an internet browser and navigate to
configuration page to load. Adjust settings as required for the installation.
NOTEs:
•
Default values for the ZEN module are shown below (Tones Mix on ALL: 20%, Phone Mix on front only: 100%)
•
If the ZEN module is still connected to the vehicle while configuring via the web-tool, a door chime will be
generated and repeated 4 times upon adjustment. To test Notification Mix volume level, go to SETTINGS,
BLUETOOTH, then select 'Add a Bluetooth Device'. Selecting this emits an audible OEM message which can
be adjusted via the mix slider.
Strip Audio sends only door chimes/ safety alerts out on that RCA channel (removes all
music). If music must play through the channel, you must use Tones Mix. Adjust tone
output level to suit. NOTE: this setting CANNOT be used simultaneously with 'Tones Mix'.
A²B® is a registered trademark of Analog Devices Inc.
ZEN configuration: Analog Outputs (online tool)
zen.local/
(forward slash must be present). Wait for the
BHM
11/01/18
NTV-DOC320
Tones Mix channels will
play audio normally until a
door chime or other safety
alert is requested, at which
time the tone will be heard
along with the audio on
that channel. Adjust tone
output level to suit.
Notification Mix channels
will play audio normally
until a notification tone is
received/active, at which
time the audio will
attenuate and the tone will
be output on that channel.
Adjust output level to suit.
Notification tone example:
NAV turn prompts, certain
CarPlay notifiers, etc
Use the LINK button to
simultaneously adjust all
the levels (for front & front
center, or rear). Select, then
adjust the slider to suit.
Use the UNLINK button to
separately adjust each
channel level. Select, then
adjust the slider to suit.
7 |
P a g e
Advertisement
Table of Contents
