Maintenance - Craftsman 315.115860 Operator's Manual

DIGITAL GAUGE
See Figures 12 - 14, page ii.
The digital gauge is multifunctional. It serves as a pressure
gauge, monitors the amount of pressure being applied to
the item being inflated, and can change air pressure mea-
surement units from psi to BAR to kg/cm
To turn the digital gauge ON, press the ON/RESET button
or depress the switch trigger.
NOTE: Make sure digital gauge is set at 0 before use. If
gauge reads "Err" or needs resetting, press and hold ON/
RESET button for 3-6 seconds.
NOTE: The digital gauge will automatically shut off when
not in use for 2 1/2 minutes or more.
To use the pressure gauge feature:
 Turn digital gauge on by pressing ON/RESET button or
depressing and releasing switch trigger.
 Place air chuck over valve stem and press down.
Readout will appear on gauge.
If inflating, the air pressure will appear on the gauge as the
item is being inflated.
WARNING:
When servicing, use only identical
Craftsman replacement parts. Use of any other part
may create a hazard or cause product damage.
WARNING:
Always wear eye protection with side
shields marked to comply with ANSI Z87.1. Failure to
do so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING:
To avoid serious personal injury, always
remove the battery pack from the product when
cleaning or performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
OPERATION
To switch from psi, kg/cm
 With gauge ON, press and hold down ON/RESET
 The current measuring unit will flash. Press the ON/
.  The setting takes effect 5 seconds after the display
2
To set pressure gauge for automatic shut off:
 With gauge ON, press and hold down ( + ) or ( - )
 When desired setting has been selected, begin
 The lock-on feature must then be disengaged, and

MAINTENANCE

Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts
should be replaced at a Sears Service Center.
BATTERY PACK REMOVAL AND PREPARATION
FOR RECYCLING
10 - English
button for at least 6 seconds.
RESET button to select the desired measuring unit.
stops flashing.
buttons to select desired shutoff pressure.
NOTE: Numbers will flash while setting pressure.
Holding buttons down will make the pressure number
increase faster.
inflating. Handheld inflator will shut off once setting is
reached.
NOTE: If using the lock-on button with a preset
pressure setting, the unit will stop after the item being
inflated has reached 40 psi, 2.75 BAR, or 2.80 kg/cm
the switch trigger must be held manually for pressures
over 40 psi, 2.75 BAR, or 2.80 kg/cm
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc. come in contact with plastic parts. Chemi-
cals can damage, weaken or destroy plastic which
may result in serious personal injury.
WARNING:
Upon removal, cover the battery pack's
terminals with heavy-duty adhesive tape. Do not
attempt to destroy or disassemble battery pack
or remove any of its components. Lithium-ion and
nickel-cadmium batteries must be recycled or dis-
posed of properly. Also, never touch both terminals
with metal objects and/or body parts as short circuit
may result. Keep away from children. Failure to
comply with these warnings could result in fire and/
or serious injury.
, and BAR:
2
.
2
.
2