Saturn 2007 Outlook Owner's Manual page 122

If the engine still does not start, and the key
appears to be not damaged, try another ignition
key. At this time, you may also want to check the
fuse, see Fuses and Circuit Breakers on page 476.
If the engine still does not start with the other key,
your vehicle needs service. If your vehicle does
start, the first key may be faulty. See your dealer/
retailer who can service the PASS-Key
a new key made. In an emergency, contact
Roadside Assistance. See Roadside Assistance
Program on page 509.
It is possible for the PASS-Key
"learn" the transponder value of a new or
replacement key. Up to 10 keys may be
programmed for the vehicle. The following
procedure is for programming additional keys only.
If all the currently programmed keys are lost or do
not operate, you must see your dealer/retailer or a
locksmith who can service PASS-Key
keys made and programmed to the system.
See your dealer/retailer or a locksmith who can
®
service PASS-Key III+ to get a new key blank that
is cut exactly as the ignition key that operates
the system.
122
®
III+ to have
®
III+ decoder to
®
III+ to have
To program the new key:
1. Verify that the new key has a
on it.
2. Insert the already programmed key in the
ignition and start the engine. If the engine
will not start, see your dealer/retailer for
service.
3. After the engine has started, turn the key to
OFF, and remove the key.
4. Insert the key to be programmed and turn it to
the ON position within five seconds of the
original key being turned to the OFF position.
The security light will turn off once the key
has been programmed.
5. Repeat Steps 1 through 4 if additional keys
are to be programmed.
If you are ever driving and the security light comes
on and stays on, you may be able to restart your
engine if you turn it off. Your PASS-Key
system, however, is not working properly and must
be serviced by your dealer/retailer. Your vehicle
is not protected by the PASS-Key
this time.
1
stamped
®
III+
®
III+ system at