Using The Analog Outputs (If Equipped); Analog Output Connectors; Channels 1-16, Emg Signals; Channels 1-64, All Signals - Delsys Trigno User Manual

Using the Analog Outputs (if Equipped)

The Trigno System provides simultaneous analog signal reconstruction of data
being detected by all active sensors. These signals are made available on the
68-pin connectors located on the Base Station and range cover the +/-5V range.
Analog outputs are engaged through software and are only available for specific
sensor sampling configurations. Refer to software user-guides for details.
Figure 7: Analog Output Connectors on Base Station.

Analog Output Connectors

Channels 1-16, EMG Signals

The pinout of this connector replicates the pinout of the Bagnoli desktop EMG
systems to facilitate connectivity between shared equipment for the Channels
1-16. This connector is a 1.27mm, PCS series connector and is compatible
National Instruments data acquisition modules.

Channels 1-64, all Signals

This connector makes available all 64 analog output channels in the 68-pin
connector. This connector is a 1.27mm, PCS series connector and is compatible
National Instruments data acquisition modules.
Trigno™ Wireless Biofeedback System
- 23 -