Acquiring Data With The System; Pc Software Installation; Pairing The Sensors With The Base Station - Delsys Trigno User Manual

Acquiring Data with the System

PC Software Installation

Trigno Galileo supported software (EMGworks & Galileo Analytics) for
Microsoft Windows Operating Systems can be downloaded from the Delsys
website (www.delsys.com) or installed following the information included with
the system. Acquiring data with a PC requires the Trigno Base Station to be
connected via the USB port. The Trigno Base Station uses a custom RF protocol
to guarantee high data bandwidth across 16 sensors with no inter-sensor
latency. Refer to the software user guides and help information for detailed
explanation of software functions. Data collection and sensors configuration is
initiated through the software.

Pairing the Sensors with the Base Station

Data acquisition functions of the sensor, wireless transmission to the base
station and data transfer from the base station to the software require the
sensors to be paired to the base station. The pairing process links the unique ID
of the sensor to the unique ID of the base station to establish a wireless data
link. Pairing information is retained after the base station and sensors are
powered off. Pairing is initiated through the software pairing command and
completed by activating the internal magnetic switch in the sensor. The
magnetic switch in the sensor is activated by tapping the sensor over the built-
in magnet of the base station, indicated the lock decal.
Figure 6: To pair the sensors with the base station: a) initiate a pair command from
software, b) tap the sensor on the base station magnet, c) confirm green blinks for
successful pair.
Trigno™ Wireless Biofeedback System
a)
b)
- 19 -
c)