Table of Contents
Advertisement
5.6.7
Output Services
This window gives information about services to be released on the RF output.
Select the RF output (RF 1 to 4) to work on and then expand the data tree to set
the parameters in order to release services at the output:
LCNs Network identifier: It is the number that identifies the network
where the signal is distributed.
Network name: It is the name that identifies the network where the
signal is distributed.
Transport stream identifier: It is a number that identifies a specific
transport stream.
Original network identifier: It is a number that identifies the network
from where the signal comes.
Private data specifier: Data that the receiver uses to properly identify
the LCN value.
Input: Select the SAT input (from 1 to 4) to select services. Click on
"Change selection" to change the input SAT.
Generated services: It shows services generated from the selected
transport stream. User can select services by clicking on "Change
selection" button.
If the user wants the same settings at all RF outputs, just fill the fields at the
right box and click on "Use for all outputs".
18
Figure 14.
November 2018
Advertisement
Table of Contents
