Blueair (including but not limited to those set out under this User Manual). You agree that you are solely responsible for your own conduct while using this product, and for any consequences thereof.
General A 4,5 m cable connects the control knob to the Blueair Cabin P1 car air purifier main unit so that it can be installed behind a The car air purifier is designed for use in small to backseat headrest.
Use only the mounting strap included in the box and ensure that the unit is securely fastened as specified. Blueair disclaims all liability for any harm or accident caused by improper instal- lation, usage, disassembly and maintenance by any user or third party.
Page 5
To avoid injury it is important not to install the unit in front of, or near the safety airbag which is normally located in the dashboard in front of the front passenger seat. CAUTIONS: Only use the power cable provided with your car air purifier to plug directly into an appropri- ate 12V power outlet in a car.
Blueair Cabin P1 car air purifier 1. Open and unpack the box IMPORTANT! 2. Read the User Manual and Quick Start Guide Please note that the Particle+Carbon filter is not Please refer to www.blueair.com for more mounted inside the unit when purchased. The filter is information.
PM10 Formaldehyde IMPORTANT! Use only genuine Blueair filters to ensure proper function of your unit and to qualify for full warranty coverage. Filter checklist To make it easy to find the right filter in the future, please fill in the customer record below and keep this user manual for reference.
Getting started 1. Remove the top cover 2a. Install the filter 1. Place the purifier unit 1. Remove the plastic on a flat surface or car bag from around the seat and release the top filter and pull the two cover by pressing the left sides of the filter apart and right release locks IN...
Page 9
2b. Attach the mounting strap 5. Connect control knob and 12 V power supply 1. With purifier unit base Connect the control face down on a flat 5 cm knob with power supply surface, thread the into the 12 V power mounting strap through supply port located near the two silver buckles...
3. The cleaning time depends on the cabin volume of the cars in question. Blueair Cabin P1 car air purifier is recommended for use in cars up to mid-size (see table on page 12).
Page 11
3. Turn on To turn unit on press When the unit is turned once. on, the start up sequence begins and the fan starts in the last Note: setting. The unit must be connected to the power supply port and powered up (i.e. the car´s ignition is on.) 4.
Page 12
High) - or press and hold for 3 seconds to turn the unit to idle mode. Note: The cleaning time depends on the cabin volume of the cars in question. Blueair Cabin CLEAN CYCLE PROGRAM P1 car air purifier is recommended for use in HIGH cars up to mid-size (see table).
6. Idle mode 7. Notification Press the control knob 3 red LEDs blink in a for and hold for 3 triangle formation seconds. Any LEDs that should a notification or are on will fade out error occur (see table during a period of 2 below).
9. Changing the filter A filter change alert is Note: displayed on the The recommendation of approximately 6 control knob when a months/180 days between filter changes is filter change is due. based on a usage of 360 hrs during that period (2,5hr * 6 days * 4 weeks * 6 months).
Help and support If you have questions about Blueair products, please visit www.blueair.com. Warranty information The Blueair Limited Warranty applies only if the unit is installed, used, and maintained according to the instructions in this manual. ARTWORK for 501089_User_Manual_P1_EN_Rev02.indd 15...
Page 16
Blueair AB Blueair AB Middle East, Jafza One, Karlavägen 108 Office No. AB1503 115 26 Stockholm Jebel Ali free Zone, P.O. Box No. 263947 Sweden Dubai, United Arab Emirates Tel: +46 8 679 45 00 Ph :+971 (4)8821244 Fax: +46 8 679 45 45 Email : salesme@blueair.se...
Need help?
Do you have a question about the Cabin P1 and is the answer not in the manual?
Questions and answers