Fhiaba Integrated Series Installation Manual page 35

>To turn on all the appliance compartments,
press the Unit button for three seconds. The
display will show the message "Initial test" for
approx. 2 minutes. After this phase the compres-
sors will start up and remain on until the default
temperature set up in the factory is reached. Do
bear in mind that this condition could last several
hours during which time the display will continue
to flash the 'Start Up Phase' message.
> If the appliance is provided with an Ice Maker,
prior to switching it on
make sure that the water filter cartridge is in-
stalled (unless water supply source is already fil-
tered by other means such as reverse osmosis).
> Purge air from the water lines by enacting
the 'Manual Clean' function from the Menu-
>Functions->Water Filter options. You may need
to complete this sequence several times until you
stop hearing air sputtering from the ice maker fill
tube.
> Once you are satisfied that the system is pur-
ged of air switch the Ice Maker on by touching the
button which will illuminate.
Note: If the TriMode drawer is configured as
a Fridge or a Fresco compartment the ice
maker will be disabled. Default mode for
the TriMode drawer is Freezer.
> For further information about the appliance
operation, refer to the User Manual.
If at the first start - up the message Stand
by does not appear, but other messages ap-
pear, such as Fridge too warm, Fresco too
warm, Freezer too warm, or sound signals
are activated, it means that the appliance
has already started the cooling process.
If this is the case, deactivate any possible
acoustic signals by pressing the Alarm but-
ton, close the door and wait until the set
temperature is reached.
Fhiaba is constantly researching new way to im-
prove the features and the design of their products,
therefore models are often upgraded and reviewed.
www.fhiaba.com · info@fhiaba.com
It is necessary to let the unit reach the correct
temperature before foods are stored inside.
On models with a dedicated Fresco com-
partment, the Fresco compartment cools to
the set temperature (default 0°C / 32°F) prior
to the cooling system switching to the main
refrigeration compartment.
EN EN
35