Table of Contents
Advertisement
UU438DH_ENG.fm Page 9 Monday, June 13, 2005 7:00 PM
Installing a Replacement Battery
Follow the steps if you need to replace a battery.
1
Press down on the handset battery
case cover (use the finger indention
for a better grip) and slide the cover
downward to remove.
2
Remove the existing battery and
unplug the connector from the jack.
3
Plug the battery pack connector
(red, black, and white wires) into the
jack inside the battery compartment.
(The connector notches fit into the
grooves of the jack only one-way.)
Match the wire colors to the polarity
label in the battery compartment, and
push the connector in until you hear a
click.
4
Make sure you have a good connection
by slightly pulling on the battery
wires. If the connection is secure, the
battery jack will remain in place.
5
Place the battery case cover back on
the handset by sliding it upwards
until it clicks into place.
Notes:
• Use only the SANYO battery (BT-0001) supplied with your
phone.
• Don't place the charger in direct sunlight or subject it to high
temperatures. The battery may not charge properly.
Rechargeable Lithium Ion Batteries
Must Be Recycled or Disposed of Properly
–
–
E9
Advertisement
Table of Contents
