Table of Contents
Advertisement
Setting
Standby mode
This function is available when operating the projector via
network.
Normal ....... Supply the power to the network function
even after turning off the projector. You can
turn on/off the projector via network, modify
network environment, and receive an e-mail
about projector status while the projector is
powered off.
Eco ............. Select "Eco" when you do not use the
projector via network. The projector's
network function will stop when turning off
the projector.
Refer to the owner's manual "Network Setup and
Operation."
✔
Note:
•When selecting Normal, the cooling fans may be running
depending on the temperature inside the projector even if the
projector is turned off.
Power management
For reducing power consumption as well as maintaining the
lamp life, the Power management function turns off the
projection lamp when the projector is not operated for a
certain period.
If the input signal is interrupted and no button is pressed for
more than 30 seconds, the timer display with "No signal"
appears. It starts the countdown until the lamp is turned off.
Use the Point
7 8
Select one of the following options:
Ready ................... When the lamp has been fully cooled
Shut down............ When the lamp has been fully cooled
Off ........................ Power management function is off.
52
buttons to set the countdown timer.
down, the POWER indicator changes to
green blinking. In this condition, the
projection lamp will be turned on if the
input signal is reconnected or any button
on the top control or remote control is
pressed.
down, the power will be turned off.
Power management
Time left before Lamp is off.
Press the SELECT button at
Power management and this
dialog box appears. Use the
Point
one of the three options.
Press the Point
select the timer, and then
use the Point
set timer.
7 8
buttons to choose
d
button to
7 8
buttons to
Advertisement
Table of Contents
