Sanyo PLC HF15000L Owner's Manual page 42

Computer Input
MENU
Return to the IMAGE ADJUST Menu. Any settings that
have been changed will not be stored. To store the changed
settings, be sure to select "LIST" and go to the COLOR
MANAGEMENT LIST.
4
In the COLOR MANAGEMENT LIST, the adjusted color data
are checkmarked. You can decide whether or not to apply the
adjusted color data in the list to the projected image (see
below).
LIST MODE
Clear the check mark if you do not want to apply the adjusted
color data; select the check mark and then press the SELECT
button. The check mark disappears.
COLOR PALETTE
Return to the COLOR SELECTION mode so that you can
readjust the setting for the color in that line. (This option is
not available if the check mark is cleared.)
DEL
Select the DEL box if you want to delete the adjusted data.
Press the SELECT button and a confirmation box appears and
then select [Yes].
ALL DEL
Delete all the data in the list. Press the SELECT button and a
confirmation box appears and then select [Yes].
MENU
The same function as stated above.
COLOR M.
The same function as stated above.
Color temp.
Use the Point 7 8 buttons to select the desired Color temp.
level (XLow, Low, Mid or High).
White balance (Red)
Press the Point 7 button to lighten red tone; press the Point
button to deepen red tone (from 0 to 63).
8
White balance (Green)
Press the Point button to lighten green tone; press the
7
Point button to deepen green tone (from 0 to 63).
8
White balance (Blue)
Press the Point button to lighten blue tone; press the
7
Point button to deepen blue tone (from 0 to 63).
8
4
COLOR SELECTION MODE
Level and phase
adjustment palette.
LIST
COLOR M.
LIST MODE
COLOR PALETTE
MENU
ALL DEL
Gamma
adjustment palette.
MENU
DEL
COLOR M.