Connecting The Ac Power Cord - Sanyo PLC HF15000L Owner's Manual

Sanyo projector user manual
Table of Contents

Advertisement

Connecting the AC Power Cord

This projector uses nominal input voltages of 200-240 V AC. It
is designed to work with single-phase power systems having a
grounded neutral conductor. To reduce the risk of electrical shock,
do not plug into any other type of power system.
If you are not sure of the type of power being supplied, consult
your authorized dealer or service center.
Connect the projector with all peripheral equipment before turning
on the projector.
A power cord clamp is designed to prevent the AC power cord
from coming loose. Attach the power cord clamp and AC power
cord to the projector by following these steps.
1
Insert the both ends of the power cord clamp into the
holes and tilt the clamp.

Connect the AC power cord to the projector.

Secure the power cord connector with the clamp.
CAUTION
The AC outlet must be near this equipment and must be easily
accessible.
✔Note:
• Unplug the AC power cord or turn off the MAIN ON/OFF
Switch when the projector is not in use. When the projector
is in stand-by mode, it consumes a little electric power.
NOTE ON THE POWER CORD
AC power cord must meet the requirements of the country where you use the projector. Confirm the AC plug type with
the chart below and proper AC power cord must be used. If the supplied AC power cord does not match your AC outlet,
contact your sales dealer.
Projector side
To POWER CORD
CONNECTOR on your
projector.
For the U.S.A. and Canada
Ground
To the AC Outlet.
(00-40 V AC)
1
Power cord clamp


AC Outlet side
For Continental Europe
To the AC Outlet.
(00–40 V AC)
Installation
Holes
For the U.K.
Ground
To the AC Outlet.
(00–40 V AC)


Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Plc-hf15000l - 15000 lumensPlc-hf15000l

Table of Contents