Table of Contents
Advertisement
Handle
•
Open out the handle and screw the handle parts with the two
screws and plastic nuts. Put the recoil starter on the right of the
handle and fix the cable with the plastic collar.
•
Introduce the rope of the recoil starter handle on its support
guide rope.
Armrest Panel
Accessories:
•
1x plastic panel in red
•
2x plastic washers in black
•
4x self-tapping screws
Installation steps:
1. First find the support catch and insert the black
plastic washers into the support catch with their
mounting holes facing outward (as shown in the
following figures).
Assembly and Remove the battery
Assembly
1. Press and hold the
battery latch buttons
at both sides of the
battery pack.
BBT-LM-SPBSES
ASSEMBLING
2. Make sure latch on
bottom
of
battery
pack snaps in place
and that battery pack
is fully seated.
2. Properly position the backing panel so that the back
plate screw holes can match the plastic washers for
proper mounting.
3. Tighten the screws, end of assembly.
Remove
1. Press and hold the
battery latch buttons
at both sides of the
battery pack.
2. Remove battery pack
from the mower.
WWW.BBTA.COM.AU
9
Advertisement
Table of Contents
