Connect The Cables In Both Ends; Before Use, Reset The Motors; Place The Velcro On The Bedframe And Put On The Cover; Slide The Mattress Towards The Foot End - RotoBed Care Manual

Connect the cables in both ends, and place the O-ring D). Connect
the remotecontrol E), it can be connectet on both sides of the bed.
Before use, reset the motors (please see User manual chapter 13.)

Place the velcro on the bedframe and put on the cover.

Insert the support for the footmatress in the holder and tighten the
screws from the inside (adjust the bed in the height to get access)
Place the 3 lower buttons in the grooves at the bottom of the bed.

Slide the mattress towards the foot end.

Press from the sides the two buttons in the centre until it is fixed
This is also the way to fix the little mattress for the feet
D)
D)
E)