RotoBed Home Manual

Mounting of the mattress

RotoBed®Home comes with a mattress consisting of a main part and a foot part.
The main mattress has 5 buttons on the back. First place the three lower buttons in the grooves at the
bottom of the bed. Slide the mattress towards the foot end. Now press the two buttons in the centre
of the mattress into the corresponding holes in the middle of the bed.
Similarly, the foot mattress has two buttons, which fit into the two round holes in the bed.

Mounting of side rails

RotoBed®Home can be delivered with side rails made of metal or oak laminate. Regardless of the
material the side rails are mounted and removed in the same way:
Press the small fitting underneath while lifting the side rail.
The side rails can simply be put back into place and will automatically lock.
Do not leave the side rails upright and loose in the bracket. This may cause squeeze risk and damage to
the bed during rotaion.
Note: RotoBed®Home should not be used by people without an introduction in the use of the bed.
RotoBed®Home is CE-marked according to directive (EU) 2006/42/EF.
RotoBed®Home should be operated exclusively with the remote control. Be sure that children are aware of the
squeeze risk when adjusting the bed's positions. When the bed's leg part is raised, do not overload it with heavy
objects or persons.