Biocomp GRADIENT MASTER 108 Operating Manual page 24

screws that hold the motor shafts to the tilting motor platform (tilt motor) or the stainless steel drive
spindle that bears the tube holders or the Roller plate. Locate the proper hex wrench in the accessory
kit and tighten down the set screws. The Tilt motor set screw is on the grey motor base on the side of
the box where the tilt motor shaft protrudes (see page 6). To get clear access to it, with the power off,
rotate the motor shaft until the set screw appears in the groove in the motor base.
3. Please help others by reporting problems to BioComp so that we can improve our products. See the
front page for contact information.
SECTION 10. Rotor run parameters follow.
22