Biocomp GRADIENT MASTER 108 Operating Manual page 18

Press ANGL, enter the value, press ENTR and the key becomes SPED. Press SPED, enter the value,
press ENTR and it cycles back to TIME.
Press NEXT to scroll between TIME-ANGL-SPED
Note: The DONE key in the TIME entry window might tempt you to press DONE to access ANGLE or
SPEED, but the DONE key on the main screen signifies that all Memories are entered and you are
ready to enter the sequence of memories.
To enter Memory2, press Mem#:
Enter the values for Mem2, then press Mem# and enter the values for Mem3. Note that higher
Memories (Mem4-9) will have values that are meaningless unless you change them. If you are using
only the first three memories, ignore the higher ones and focus on Memories 1, 2, and 3.
10.Press DONE to enter the Sequencing phase.
The sequence showing when you open this screen will originate from the last run actually used, so if
you want to start with a similar run and modify it, bring up that run from the LIST, run it and
immediately stop it (this enters it in the LAST memory). Use the NEXT and DELete key to cycle
through and remove unwanted memories and then enter the desired memory order.
In the example from above, the display shows this after the 11 steps have been entered:
When you are satisfied with the order, press RUN.
The FAST key appears during tilting and disappears when the angle is reached. STOP pauses a run
and is changed to RUN to restart the run.
HOLD stops the timer, but leaves the motors in their current state. The display changes to:
TIME will be blinking. Press the EDIT key, change the time as above and press DONE. Press NEXT,
the angle starts blinking, press EDIT, enter the three digit angle (2,0,0 = 20.0°), press ENTR and plate
tilts to the new angle. Press NEXT to edit Speed in similar fashion.
Press EXIT to leave HOLD and start timing.
Pressing the STEP key advances to the next STEP in the sequence before the current time expires. If
the current step is counting up from 0:00 m or down from a preset time (0:05), the elapsed time when
Mem 2 0:15m 87.0° 00rpm
TIME NEXT MEM# DONE EXIT
S#01of01:-------------1-
NEXT DEL RUN
S#12of11:--12121212123--
NEXT DEL RUN
05-50% S01 0:05/87.0/30
FAST STOP HOLD STEP EXIT
S /1 0:05m 87.0° 30rpm
EDIT NEXT HOLD
16
EXIT
EXIT
EXIT