4-Post Rack Installation With Standard Rails - Netspective 16Hi Installation Manuals

4A. 4‐Post Rack Installation with Standard Rails
Locate the mounting hardware and rack rail assemblies shown below
Step 1
Locate the two adjustable standard rack rail assemblies.
• Insert the tabs on the front section of the adjustable
rack rail assembly through the openings in the rear
sections of the assemblies.
• Check to make sure the adjustable rack rail
assemblies are connected correctly, then slide the
front section forward and the rear section back to
keep them from coming apart. These assemblies
adjust to accommodate different rack depths.
Step 2
• Insert a cage nut into each of the square
holes in the rack you will be using as shown
(three in the front and two in the rear).
They click into place.
• Attach the rack /rail assemblies to the rack
using two M5 x 12 flat head screws and
cone washersin the front and back. The
convex side of the conewashers face toward
the rack.
• Make sure the rack/rail assemblies and
screws are aligned in the rack not only
in the front and back, but are level in
height on the left and right sides for proper
alignment for appliance installation.
NetSpective Web Filter •
16Hi Hardware Installation Guide
NOTE:
Sections 6A
and on page 9 are for use with the rails
and hardware provided in your ship kit.
If different style rails are being used, or
if your rack requires different hardware,
refer to the instructions provided with
your rail's or rack's ship kit.
Rack bracket tab
the adjustable
rack rail assembly
Empty
hole
Adjustable rack rail assemblies
4-post rack
The installation procedures for
below, and 6B, 4‐Post Rack,
Rack bracket tabs
the adjustable
rack rail assembly
Empty
hole
Empty
hole
Page 5