3.
Unpacking the 4‐Post Rack Installation Assemblies
Verify that the ship kit includes one of the following installation assemblies
Installation Assembly A ‐ Standard Rail Assemblies
with Mounting Hardware
•
Two power
cords*
•
A set of 4‐post rack mounting
(Eight) M5 x 12
Phillips flat head screws
•
A pair of 4‐post rack sliding chassis rail rack assemblies that attach directly to the rack
Rack rail assembly, inside view
Rack rail assembly, outside view
Installation Assembly B ‐ Quick Mount Rails (for use in 4‐post racks with square holes only)
•
Two power
cords*
•
Two 10‐32 x 3/4" Phillips pan head
(Two) 10‐32 x 3/4"
Phillips pan head screws
(used to secure the appliance in the rack)
•
A pair of adjustable quick‐mount rack rail assemblies (requires no additional mounting hardware or tools)
Quick-mount rack rail assembly, inside view
Quick-mount rack rail assembly, outside view
NetSpective Web Filter
hardware**
(Eight) M5 x 12
(Ten) M5
cone washers
cage nuts
Adjustable front rack rail assembly
screws**
Adjustable front quick-mount rack rail assembly
•
16Hi Hardware Installation Guide
(Two) 10‐32 x 3/4"
Phillips pan head screws
(used to secure the appliance in the rack)
Adjustable rear quick-mount rack rail assembly
NOTE:
Use the hardware supplied
with your specific rack if different
from the hardware supplied in
this kit.
NOTE:
Only two power cords will
*
be included in your ship kit even
if you receive multiple rail kits.
NOTE:
There may be additional
**
mounting hardware included
that will not be used with this
installation assembly kit.
Adjustable rear rack rail assembly
Page 4