Table of Contents
Advertisement
Basic Operation
Turning On the LCD Projection Monitor
1
Connect the LCD Projection Monitor's AC power cord into an
AC outlet and the POWER indicator turns into red.
2
Press the POWER ON-OFF button on the front panel of the LCD
Projection Monitor or the remote control. The cooling fans start
to operate. The POWER indicator blinks green rapidly for 15
seconds.
3
The POWER indicator emits green light then the input source
and the lamp mode that were selected last will be displayed on
the screen.
NOTE:
●
While the POWER indicator blinks green rapidly, no operation of the remote control and
the front panel can be accepted.
Turning Off the LCD Projection Monitor
Press the POWER ON-OFF button on the front panel or on the remote
control.
The POWER indicator turns into orange, and it continues while the
cooling fans are operating (for about 4 minutes). The LCD Projection
Monitor can be turned on again during this period or after the indicator
turns into red.
When the LCD Projection Monitor has cooled down enough, the
POWER indicator emits red light. Then you can disconnect the AC
power cord.
TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU TURN
YOUR LCD PROJECTION MONITOR ON, WAIT AT LEAST
5 MINUTES BEFORE TURNING IT OFF.
DO NOT DISCONNECT AC POWER CORD
COOLING FANS ARE RUNNING OR BEFORE POWER
INDICATOR EMITS RED LIGHT. OTHERWISE IT WILL
RESULT IN SHORTENING LAMP LIFE.
NOTE:
●
Do not use the LCD Projection Monitor for more than 24 hours continuously. Turn off the
LCD Projection Monitor at least once in 24 hours and give it a rest. Continuous use may
result in shortening the lamp life.
●
This LCD Projection Monitor monitors internal temperature and automatically controls the
running speed of the cooling fans.
●
If the WARNING indicator blinks or emits red light, see "Warning Indicator" on page 45,
51.
18
Front Panel
ECO
POWER
INPUT 5
(MONO)
RENCE)
VIDEO
L–AUDIO–R
POWER ON-OFF button
Selected Input Source and Lamp Mode
WHILE
Remote Control
LL
LAMP
CONTROL
AUTO PC
LAMP
MENU
SCREEN
INPUT
SELECT
M
FREEZE
POWER ON-OFF button
+
Selected input source
Selected lamp mode
Advertisement
Table of Contents
