Table of Contents
Advertisement
CONNECTION
Before connecting your system, make sure that all units are
turned off.
Multiple Connection
Multi-connection is possible using the loop-through feature of
this unit.
When this monitor is connected to additional monitors, the same
picture can be obtained on all the connected monitors. Set the
final monitor to 75 Ω termination state.
Coaxial cable
To Video input terminal
Monitor
Video recorder
Note:
•
Do not leave a unused cable and do not connect BNC
connector to the last jack of the monitor. Only once connection.
•
The components and connection cables are not included and
must be purchased separately.
TROUBLESHOOTING
Solutions to common problems related to your monitor are described here. If none of the solutions presented here solves the
problem, unplug the monitor and consult a SANYO-authorized dealer or service center for assistance.
Problems
No power supply.
No picture with the
power on.
Shaking picture.
Picture is too bright
and hard to view.
The following are not malfunctions:
•
You experience a mild electric shock when you touch the picture tube. This phenomenon is due to a normal buildup of static
electricity on the CRT and is not harmful.
•
The monitor emits a strange sound when the room temperature changes suddenly. This is only a problem if an abnormality appears
on the screen as well.
•
If two or more monitors are operated next each other, their images may shake or be distorted. This phenomenon is due to mutual
interference; it is not a malfunction.
Move the monitors away from each other until the interference disappears or turn the power off on any monitor that is not being
used.
Video camera
Points to be checked
Is the power plug loosened or disconnected?
Is the video signal output from the connected
component?
Is the input signal selected properly?
Is the video cable disconnected?
Is the monitor close to a device generating a strong
magnetic field?
Has the termination switch been set correctly?
BASIC OPERATION
1
Press the POWER switch to turn on the power.
ON: The power is turned on (the POWER indicator is lit).
OFF: The power is turned off (the POWER indicator is off).
2
Select the picture input.
Use the monitor selector switch at the front of the monitor to
select the picture being input to either the A or B input
terminal.
NOTE: If there is no input source connected to either the A or B
input terminal, no picture will appear when that input
terminal is selected.
3
Adjust the picture.
Adjusting the picture brightness
Turn the BRIGHT control to the left or right to adjust the
picture brightness.
Right: The picture becomes brighter
Left:
The picture becomes darker
Adjusting the picture contrast
Turn the CONTRAST control to the left or right to adjust the
picture contrast.
Right: The picture becomes sharper
Left:
The picture becomes softer
Firmly insert the power plug.
Set the connected component correctly.
Select the required video signal input with the
Monitor selector switch. (See page 3.)
Connect the video signal cable firmly. (See page 4 or 5.)
Move the device away from the monitor until the
picture stabilizes.
Move the termination switch to the correct setting.
5
Measures (Remedy)
Advertisement
Table of Contents
