Subscribe to Our Youtube Channel
Related Manuals for Sunmi T2 series
Summary of Contents for Sunmi T2 series
- Page 1 User Manual Book Before operating this unit please read these instructions completely and save them...
- Page 2 Introduction to POS Three options for sub screen of T2 〃 “Take dual 15.6 as sample” Primary display Paper exit of printer 〃 〃 〃 〃 〃 15.6 main screen only 15.6 main screen+10.1 15.6 main screen+15.6 Cover handle of printer （L1521）...
- Page 3 POS Machine Installation Interface cover Secondary display TF card slot Micro USB debugging port Debugging function button Cable cover Open the paper roller cover Connect the power cable Pull the printer handle out, and the Connect the power interface of the adapter to the paper roller cover pops out power port at the bottom of the POS.
-
Page 4: Common Troubleshooting
Wrong Operation Paper Jammed Troubleshooting Firstly, open outward the Secondly, adjust the cutter knob cover of the printer cutter upwards until it is removed. Please do not tilt the printing paper. Please do not get printing paper Do not pull the printing paper roll caught in the aperture of the in the paper case tray too long. -
Page 5: Specification
Specification Name and Content of Toxic or Harmful Substances in this Product Operating system Android 7.1 Processor Qualcomm Snapdragon Qcta-core Toxic or Harmful Substances or Elements 15.6-inch FHD1920 × 1080 resolution Main-screen 16GB ROM + 2GB RAM Memory Part Name Lead Mercury Cadmium... - Page 6 Precautions FCC Regulations: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: Warning Important Safety Instructions (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the T2 series and is the answer not in the manual?
Questions and answers
Printer cutter error
The printer cutter error in Sunmi series printers is caused when the cutter gets stuck. This is referred to as "CutterError" or Cutter exception 1.
This answer is automatically generated
I like to change the user, i.e. the email address. How can I do this?