Table of Contents
Advertisement
DO NOT EXCEED RATED CAPACITY.
OVERLOADING CAN CAUSE DAMAGE TO OR
FAILURE OF THE TRANSMISSION JACK.
KEEP HANDS AND BODY CLEAR OF ALL PINCH
POINTS. READ AND UNDERSTAND THIS MANUAL
BEFORE OPERATING THE TRANSMISSION JACK.
THIS TRANSMISSION JACK IS DESIGNED FOR USE
ONLY ON HARD LEVEL SURFACES CAPABLE OF
SUSTAINING THE LOAD. USE ON OTHER THAN
HARD LEVEL SURFACES CAN RESULT IN THE
INSTABILITY OF THE TRANSMISSION JACK AND
POSSIBLE LOSS OF LOAD.
FAILURE TO HEED THESE WARNINGS MAY RESULT
IN LOSS OF LOAD, DAMAGE TO THE TRANSMISSION
JACK , AND/OR FAILURE RESULTING IN PROPERTY
DAMAGE, PERSONAL OR FATAL INJURY.
ASSEMBLY INSTRUCTIONS
1. Locate the two, "leg assemblies", and attach them
together using the 3 bolts, washers and nuts
provided. Leave finger tight for now.
2. Attach the casters to the ends of each leg, one at
a time making sure to snuggly tighten them using
a 17mm open end wrench and the provided thin
wrench.
3. Place the cylinder assembly onto the leg assembly
and bolt in place using the 3 bolts and washers
provided. Make sure to snuggly tighten these bolts.
4. Tighten the bolts and nuts attached to the leg
assembly in step 1.
5. Attach the support bar ring using the 4 bolts, washers
and nuts provided. Leave finger tight for now.
6. Attach the 4 support bar's using the 8 bolts,
washers and nuts provided. Make sure to snuggly
tighten these bolts.
7. Tighten the bolts and nuts attached to the support
bar ring in step 5.
8. Attach the Tow Handle.
9. Attach the angle plate brackets onto the saddle, and
fasten with the hex bolts and nuts.
10. Assemble the stationary plate bracket on the angle
plate bracket and secure with the hook and screw
caps. Assemble chains and chain hardware to the
corner of the stationary plate bracket.
DO NOT RAISE, LOWER, OR TRANSPORT A
TRANSMISSION UNLESS IT IS SECURED BY THE
RESTRAINT SYSTEM. IT IS YOUR RESPONSIBILITY
TO ADJUST THE RESTRAINT SYSTEM TO A
SUITABLE POSITION. BENDPAK / RANGER IS NOT
SUBJECT TO ANY RESPONSIBILITY FOR
INCORRECT SETUPS OF THE RESTRAINT SYSTEM
THAT MAY CAUSE PERSONAL INJURY AND / OR
PROPERTY DAMAGE.
SETUP INSTRUCTIONS
1. To prevent oil leak during shipment, the breather plug
is tightened down to ensure the best sealing function.
Before the first use, losen the breather plug 1 full turn.
2. The reservoir tube is shipped filled with hydraulic
oil. Before using the jack for the first time, press the
release pedal to open the release valve, and operate
the foot pump eight full strokes to distribute the oil.
BLEEDING AIR FROM THE
HYDRAULIC SYSTEM
Air can accumulate within a hydraulic system during
shipment or after prolonged use. This entrapped air
causes the jack to respond slowly or feel "spongy." Use
the steps below to bleed the system.
11. Pump the jack to the highest point where the first and
the second piston rams are both at maximum height.
12. Get the help of another person to keep the release
pedal depressed, and activate the foot pedal about 20
times.
13. Let go of the release pedal; the air in the oil system
should be bled successfully
4
Advertisement
Table of Contents
