Happy HCH-701 Quick Reference Manual

HAPPY HCH‐701 Journey Reference Card 1 of 2: Design Setup
Follow the 4 steps on this card to set up a design. The next card #2 will then take you through sewing.
1. Read in a Design from a USB flash drive. From the
Drive screen, press the menu icon as shown by the arrow.
Insert a USB flash drive into the machine,
and press then
A list of design appears as shown, right.
Select a design to load and press
to return to Drive mode.
2. Choose design thread colors. Press the Needle
button on the
Drive screen as
shown. The
screen shown on
the right appears.
Set design colors
by following these
directions.
Assign a frame out to selected section
3. Choose a hoop.
Press the Frame
button in the Drive
screen, then ,
Select hoop type here
which makes
the screen on the
right appear. Choose
a hoop then go to
step 4.
.
Choose a
design
from the
list.
Arrows select
which section of
the design.
Choose needle
number/ color
Assign a Stop to
selected section
(i.e. appliqué)
PTA 32320 320mmx320mm
Design & hoop
PTA 32320 320mmx320mm
outline displayed
here
Select hoop from this list
HAPPY HCH‐701 JOURNEY QUICK REFERENCE GUIDE
Happy machine at the drive (sewing) screen
4. Adjust/check design position
& fit. After choosing a
hoop, press this button
to return to the screen
shown on the right.
Move design to center
The highlighted
of sewing field
Sewing position to origin
buttons perform
Trace mode, calls up these
the functions buttons to let you start, stop,
pause and step through the
trace.
indicated.
Move hoop or design position.
USB flash
drive port
is on this
side behind
the control
panel.
PTA-150