Sanyo Xacti VPC-E2 Instruction Manual page 132

EDITING VIDEO CLIPS
4
Specify the start point of the extract.
h Use the procedure below to specify the frame from which the video
clip extract will start.
h Play the video clip until approximately the desired point, pause the
video clip, then play the video clip one frame at a time, stopping at the
start point of the extract. This will be the first frame of the extract.
h If the start point of the video clip is also the start point of the extract,
proceed to step 5.
<Procedure>
Play:
After pausing playback, press and hold the [H] button for about
2 seconds for forward playback, or the [G] button for reverse
playback.
Pause:
During playback, press the SET button.
Accelerated playback:
During playback, press the [G] or [H] button to change the playback
speed.
Single frame:
After pausing playback, press the [H] button to move forward one
frame, or the [G] button to move back one frame.
5
Press the [T/]] button.
h The start point of the video clip
extract is set, and the screen to
specify the end point appears.
h Specify the end point of the
extract by following the same
procedure as in step 4.
<When joining the first and latter
portions>
1 Press the [W/P] button.
h Each time the [W/P] button
is pressed, the sections to
delete and the sections to
save are reversed.
2 Specify the end point of the
extract. The frame following the
end point of the extract will be
the start point of the latter
portion to be joined.
115
English
Approximate playback time
CUT
SAVE
Portion to be deleted
00:00:06
End point