Attaching Oscillating Base To Easybird Auto-Feed Trap - Champion EASYBIRD 40913 Instruction Manual

3. Attaching Oscillating Base To EASYBIRD Auto-Feed
1. Remove the EASYBIRD Auto-Feed trap by unbolting it from the Trap Taxi, 3 legged stand,
or other platform.
2. Mounting to the Trap Taxi - The EASYBIRD Oscillating Base has (4) pre-drilled holes that
align with the four mounting holes on the frame of the Trap Taxi. Use the 10mm x 50mm
hex head bolts (4) and 10mm lock nuts (4) supplied with the Trap Taxi to securely fasten
the oscillating base to the trap taxi as shown. The gear motor on the top of the
oscillating base is to the front, the lock down nut and bolt is to the rear.
Trap Taxi
Mounting Holes
Bottom of
Oscillating Base
3. Mounting to the 3 legged stand or other platform - The EASYBIRD Oscillating Base has
pre-drilled holes that align with the mounting holes on the 3 legged stand used with the
Easybird Auto-Feed. Use the 10mm x 20mm hex head bolts (4) and 10mm lock nuts (4)
supplied with the 3 legged stand to securely fasten the oscillating base to the 3 legged
stand as shown. Use longer mounting bolts and any of the mounting holes to securely
fasten the oscillating base to any other platform that is being used. The mounting bolt that
is directly under the shock absorber can be installed after the oscillating base is connected
and the oscillating base can be moved slightly The gear motor on the top of the
oscillating base is to the front, the lock down nut and bolt is to the rear.
3 Legged Stand
Mounting Holes
Bottom of
Oscillating Base
6
If you require parts or service assistance, please call the CHAMPION TRAPS & TARGETS Customer Service Dept.
Front of
Trap Taxi
Mounting
Bolts
Front of
3 Legged
Stand
Mounting
Bolts
at (800) 379-1732
©2015 CHAMPION TRAPS & TARGETS, Anoka, MN 55303