Attaching Oscillating Base To 6-Packer Trap - Champion EASYBIRD 40913 Instruction Manual

CAUTION! The EASYBIRD 6-Packer or EASYBIRD Auto-Feed Trap with Oscillating Base
must be bolted down to the trailer, trap taxi, 3 legged stand, or to a flat, solid surface to
eliminate any movement of the trap while operating ! Do not install in an area that does
not allow safe access to the trap during loading and use. Provide ample clearance
around trap. The ON/OFF/SAFE RELEASE switch for each trap is located on the rear of
the trap to allow the trap to be uncocked before approaching it. Provide for safe access
to the switch that will not require anyone to walk in front of the trap to load targets or
perform work on it.
2. Attaching Oscillating Base To EASYBIRD 6-Packer Trap
1. Remove the 6-Packer trap by unbolting it from the trailer.
2. The EASYBIRD Oscillating Base has (4) pre-drilled holes that align with the four mounting
holes on the frame of the 6-Packer trailer. Use the 10mm x 50mm hex head bolts (4) and
10mm lock nuts (4) supplied with the trailer to securely fasten the oscillating base to the
trailer frame as shown. The gear motor on the top of the oscillating base is to the
front, the lock down nut and bolt is to the rear.
Front of Trailer
Mounting Bolts
3. Use the 10mm x 20mm hex head bolts, washers, and 10mm lock nuts (L-2) provided with
the oscillating base to securely fasten the 6-Packer trap to the oscillating base. Bolts should
be inserted from underneath with the washers and nuts on top as shown. The mounting
bolt that is directly over the shock absorber can be installed after the oscillating base is
connected and the oscillating base can be moved slightly using the jog switch.
If you require parts or service assistance, please call the CHAMPION TRAPS & TARGETS Customer Service Dept.
Mounting Bolts
at (800) 379-1732
©2015 CHAMPION TRAPS & TARGETS, Anoka, MN 55303
5