NVC/IPE Series
INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION
Installing a C/CS Mounting lens
1. Remove the protective rubber cap from the front of the camera.
2. Install the mount ring for lens and adjust the mount ring to fit C or CS lens.
3. Tighten the setscrews using the hexa wrench in the package.
Installing an Auto IRIS lens
1. Remove the cover of the auto iris lens plug and connect it with the lens cable.
2. Connect the auto iris lens plug to the 4-pin lens terminal on the back of the camera.
Use the connection recommended by the manufacturer. For best
i
performance, read the lens manual carefully. You may need to set the flange
back focus.
Note
i
Only DC-drive type is supported.
Note
02A.02
CCW
CW
CW
Set Screw
SET SCREW
UDP Technology Ltd.
IPE1100 Installation Guide
(For IRIS LENS)
9